SINGER 12K Family User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

10
THE
quilting
guide
.
Attach
the guide by
passing the
horse-shoe shaped clamp over the
presser bar from behind, bringing the holes in it in line with that in the
presser bar immediately above the pressor foot. Through these holes pass
the rod of the quilting guide from either side, and when guide is at proper
distance for the pattern required, tighten the quilter in position by means of
the thumb serew in the clamp. Make a straight line upon the fabric with
chalk or by creasing, and stitch upon it. Then adjust the gauge-arm the
required distance for the next line of stitching, and guide the fabric with the
line already sewn directly under the gauge-arm.
THE TRIMMER.
Attach
the
trimmer
to
the
presser
bar.
Place
the
braid,
velvet,
or
ribbon
in
the
slot
and
under
the
needle,
then
guide
the
material
and
the
trimming
to
follow
the pattern desired.