How to replace light bulb, Cleaning, Removing lint and dust – SINGER XL100 Quantum User Manual

Page 67: Caution

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CAUTION:

Be sure to disconnect plug from wall outlet before opening cover.

How To Replace Light Bulb

Using exclusive screwdriver, loosen setscrews at rear and top

side of face plate cover about two turns, and pull cover straight
off.

Remove lamp cover.

Cleaning

Removing lint and dust

Accumulation of lint or dust may cause

problems. Always keep sewing machine
clean.

CAUTION:

Be sure to disconnect plug from wall outlet
before cleaning machine.

Remove needle and presser foot, and clean

area between feed dog teeth and slots in

needle plate, using brush furnished with
machine.

Always keep area around hook and bobbin
case clean.

Remove bulb by pushing bulb
upward and turn to left.
Replace by pushing upward

and turn to right.

CAUTION:

Contact dealer for correct light
bulb replacement.

Power consumption of bulb is

5 watts.

How to Replace Needle Threader Hook Holder (Optional Part) pan N0.233075

CAUTION:

Be sure to disconnect plug from wall outlet before removing needle.

Remove needle and

presser foot.

Push threading lever halfway

down.

Place exclusive screw

driver on top of hook

holder and push down.

Align slit in new hook

holder with needle

threader shaft pin.

Push new hook holder up

from bottom with finger

until it snaps in place.