Reinforced (tapes) overedge stitching (i4u286b), Reinforced (tapes) overedge stitching, Two or three-thread pin tucking – SINGER 14U236B User Manual
Page 32: 4u286
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
21. Two or three-thread pin tucking
Pin tucking is a useful decoration when sewing blouses and children’s clothes. Pin tucking is accomplished
before cutting out garment.
Use ordinary overedge throat plate or rolled hemming throat plate.
Remove left needle.
Before sewing on your garment, always make a test stitch on a sample of your fabric so that you can
adjust the thread tensions correctly for standard 1 needle, 3 thread overedge stitching, or 1 needle 2
thread wrapped edge overlock stitching.
Place movable knife in non-operating position, (see page 21)
Fold fabric in half with the wrong side facing up.
Place fabric under the foot with the fold resting against the wall of edge guide.
Adjust edge guide so that the stitches will just overcast the edge of the fold as shown in the sketch.
Lower the foot and sew. When stitching is completed, press pin tuck to lay flat on one side.
22.
Reinforced (tapes) overedge stitching (
i
4U286
b
)
Inserting a tape while overedge stitching, will give a much more durable seam.
a.
Remove front cover screw (1) and
install tape guide attachment.
b.
Pass tape as shown in figure through
tape guide 0 , tape guide @, hole
0 in presser foot and draw to rear
from under presser foot.
30