Placing bobbin case in shuttle – SINGER W159 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PLACING BOBBIN CASE IN SHUTTLE
IMPORTANT; In the foUowing operations the needle must always
be above the surface of the machine. Raise tlie needle by turning
balance wheel TOWARD YOU by hand
REMOVING THE BOBBIN CASE (See Fig. 9)
Open the slide plate (10, Fig. 1) by sliding it out. With left thumb
and forefinger, open the
hinged latch (D) at the
front of the bobbin case
and hold securely as you
with-draw bobbin case
from the stud of the
shuttle body (C).
When held in the above
manner the bobbin wOl
not
fall
out
of
the
bobbin case.
Fig. 9
INSERTING THE BOBBIN CASE
After wmdmg a fresh bobbin and threading the bobbin case (See Fie 6 7 * S'» UoW i, uu-
thumb and forefinger. Keeping the protruding finger IF'» tn -n f ‘
^
case around the stud of the shuttle body (Cl until th r ^
bobbin
never
FORCE IT. Thr“ o7four inle/S r u
operation is easy-
needle plate hole as shown in Fig. 11.
brought up through the
- 9 -