Standby/on indicator, Front panel facilities and connections m – Onkyo M-282 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Front panel facilities and connections
m
POWER
After plugging in the power cord into the rear panel and wall
outlet, pressing this switch connects the M-282 to the AC mains.
The function of this switch differs depending on the setting of the
TRIGGER switch on the rear panel. Before turning on the power,
be sure to set the TRIGGER switch. Besides, before turning on the
power, make sure all cables are properly connected.
The TRIGGER switch is factory set to OFE.
When the TRIGGER switch is set to OFF
Pressing the POWER switch turns on the M-282. The STANDBY/
ON indicator lights orange after flashing red for 5 seconds.
Press the POWER switch again to turn off the M-282.
When the TRIGGER switch is set to 12V TRIGGER
If no signal is supplied to the 12V TRIGGER IN jack, pressing the
POWER switch enters the standby state and the STANDBY/ON
indicator lights red.
If 12V DC is supplied to the 12V TRIGGER IN jack, pressing the
POWER switch turns on the M-282 and the STANDBY/ON
indicator lights orange after flashing red for 5 seconds.
If the M-282 is in the standby state, the M-282 turns on
automatically when 12V DC is supplied to the 12V TRIGGER IN
jack.
When the signal input to the 12V TRIGGER IN jack is interrupted,
the indicator lights red and the M-282 enters standby state (Auto
Power On/Off Function).
Press the POWER switch to turn off the M-282.
When the TRIGGER switch is set to AUDIO
If no signal is supplied to the AUDIO IN jacks, pressing the
POWER switch enters the standby state and the STANDBY/ON
indicator lights red after flashing red for 5 seconds.
If an audio signal is supplied to the AUDIO IN jacks, pressing the
POWER switch turns on the M-282 and the STANDBY/ON
indicator lights orange after flashing red for 5 seconds.
If the M-282 is in the standby state, the M-282 turns on
automatically when an audio signal is supplied to the AUDIO IN
jacks.
When the signal input to the AUDIO IN jacks is not supplied for
more than 4 minutes, the indicator turns to red and the M-282
enters standby state (Auto Power On/Off Function).
Press the POWER switch to turn off the M-282.
Note:
You cannot use the Auto Power On Function when the power is
turned off. To use the Auto Power On Function, leave the M-282
in the standby state once the M-282 enters the standby state.
STANDBY/ON indicator
The STANDBY/ON indicator lights red when the M-282 is in the
standby state and lights orange when the M-282 is turned on.