Amana L0503010 - Manual (Page 6)

CAUTION: Disconnect electrical power before you start!
ALL ELECTRICAL WIRING AND GROUNDING
SHOULD BE DONE IN ACCORDANCE WITH
NATIONAL AND LOCAL CODES.
ivi /
ijijiìyTiì ;dtv bwasjTiT/topdcijiTiti g-r’itooficjbdvtiTTr i;t:j :
ipiicvv; :(ihf ■ PntoiA-ud;-wi 1 ti/ ÌTùb-f qiaiVTu
:Ì:T: ns :pN:fv.; ii : T.iiyt.fcivit: IT: AijfbfT'.'biiflf' id
V ■ bo : -y-sert; TO; TÌltó'-eìjTKiSm
. :.
This dishwasher is designed for
operation on an adequately
wired individuai 120 VAC,
60 Hz approved electrical
circuit. Use required fuse {15
amp) or comparable circuit
breaker. Two wire with ground
service to the dishwasher
is recommended for connection
at the terminal box and for
grounding.
G R O U N D I N G I N S T R U C T I O N S
w Af UdU-ÌV;:-liyrqyirTì'i itìT f-'k-ciTtoi biybqqkv ic
/H/lf;!; fiu ■UìViyjih-jyi
1 ' Lid k-Mig : ■ ÌB cO: / TUiVTUU TÌ'iifiUif: ■■■iÙ-Ty .i:' : Hbidi Li» rm /■AfftìyTt:
oUttAitfetiV'y;
ifcphintai
imììrerrts-i
This appliance must be connected to a grounded metal, permanent wiring system; or an equipment-grounding conductor
must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the appliance.
CAUTION: Disconnect electrical power to dishwasher before you start!
CHECK LOCAL PLUMBING CODES FOR APPROVED PLUMBING
PROCEDURES AND ACCESSORIES. ALL PLUMBING SHOULD BE DONE IN
ACCORDANCE WITH NATIONAL AND LOCAL CODES.
Dhlu\.r.*i SiiU’.iPW BOOR SPRING ABJUSTMINT
" *
The door lias two main springs, one located on each hinge. There are two slots on each hinge that allow
for door adjustment with the access panel removed.
To change door spring tension, use a 1/4" liex-niit driver to either loosen or tighten a single screw located
on each door spring adjustment bracket. The spring adjiistnient brackets are located on either side of the
dishwasher frame. These brackets stretch the springs by sliding forward and back along the dishwasher
frame.
To increase spring tension: (If door falls too fast) Tighten each screw by turning clockwise.
To decrease spring tension: (If door falls too slowly) Loosen each screw by turning counterclockwise.
For heavy wood panels, an auxiliary booster spring kit is available.