Making til mctmcal coniictiois, Finauzing tii instauatiol – Amana L0503010 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MAKING Til mCTMCAL CONIICTIOIS------------

SEE THE ELECTRICAL REQUIREMENTS SECTION

CAUTION: Verify power to dishwasher is off at source.

^ Remove terminal box cover.

® In order to secure the power supply cable, a UL listed strain relief must be used to secure

the power supply to the back of terminal box.

these wires to wires from dishwasher wire harness located in the terminal box. Connect
wires using the appropriate size wire nuts, twisting and tightening securely over the wire
connections. Connect white to white and black to black.

: :TiA/; ict'cficil

iil'oi:.stsiUie.-sc.iie

v'h

liJlr

ies'.AftiitepCrii /1 eji/f.t

ctibii'.'

oil wii't reiii.'Jf:

® Attach external ground wire from beliind washer of green grounding screw. If an external

groiiiidwire is used, insert the wire through the cable clamp and attach behind washer of
the green grounding screw. Attach the other end of external ground wire to a suitable
external ground. If a question arises, refer to your local
electrical codes.

Secure the strain relief and replace the terminal box cover.

Miaiii nelief

'MMm iooiop

CHECK LOCAL PLUMBING CODES FOR APPROVED PLUMBING

----------- "PROCEDURES AND ACCESSORIES.ALL PLUMBING SHOULD BE DONE

IN ACCORDANCE WITH NATIONAL AND LOCAL CODES.

Connect water supply line to water valve. Minimum 3/8" O.D, copper tubing or equivalent

SHUTOFF VALVE; Install a hand shutoff valve in the water supply line in an accessible location, such as under the sink. The shutoff is optional,
but recommended and may be required by local codes. Connections are preferable located toward the left side of dishwasher. Care should be taken
to route plumbing away from motor and blower (if equipped). DO NOT make these connections until the dishwasher is in position.

Care should be taken to protect dishwasher and water lines leading to dishwasher from freezing. Damage from freezing is not covered by the
warranty.

- FINAUZING TII INSTAUATIOl

^ Turn water supply.on and check roniiectioiis for leaks.

0. Turn power supply'OIL ;

# Re-install Acess and Toe.panels rem.Qved in step 2.

® Run ■dishvyasher.-thro.iigh Rins.e and Hold sir equivalent cycle.

@ Check .drain hose connection for leak,.. .

. .