Sears 917.25958 - Manual (Page 25)

SERVICE AND ADJUSTMENTS
TO REPLACE FUSE • Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
• BLACK cable first from chassis and then from the fully
charged battery.
» RED cable last from both batteries.
FIG. 29
TO REPLACE HEADLIGHT BULB
» Raise hood.
<■ Puli bulb holder out of the hole in the backside of the
grill.
• Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
• Check wiring. See electrical wiring diagram in the
Repair Parts section of this manual.
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
{See Fig, 30)
® Raise hood.
■’ Unsnap headlight wire connector.
“ Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
" To replace, reverse above procedures.
25