Sears 919.16225 - Manual (Page 10)

TROUBLi SHOOTING GUIDE
PROBLEM CAUSE CORRECTION
1, Doesn't draw
qhemical/deter-
gent like It
should
■ Chemical control knob not open far
enough or too far open
• Chemical/detergent not thinned
enough
• Chemical/detergent not proper type
for suction use.
• Water control knob "ON"
• Open knob gradually until you
achieve desired flow rate (2W turns
maximum)
• Add water to thin the solution
• Use Sears special deaner/degreaser
• Turn water control knob "OFF" Only
air and chemical Control knobs
should be “ON”
2. Sputters when
spraying
chemical/
detergent
® Chemical control knob open too far • Close knob until sputter stops
3. Not enough
spray force
® Water and/or air pressure too low
• Water and air control knobs not fully
open
• Surface heavily soiled
• Use Maximum water and air pres­
sure available (not to exceed 175
psig)
• Open both knobs fully
• Scrub surface with rag or sponge to
loosen dirt then rinse with air and
water control knobs "ON"
4, Chemical/deter-
gent doesn't
combine with
water pressure
inside of power
washer
• Power Washer is not designed to do
this
• To Wash or spray chemically use
cherrical and air control knobs ON
o n l y . To Rinse, use wafer and air
control knobs ON only.
I D