Sears 51271 - Manual (Page 13)

After cleaning, replace drawers and covers in
reverse order. Reinstall the gasket at the rear of the
top drawer. Fit the end of
the plastic drawer support
into the slot on the gasket,
with the rubber gasket
flap facing you. Make
sure the gasket snaps
into place.
Then replace the light
panel by honging top of
panel on upper pins and
pushing in at bottom.
Drain Opening in Freezer Compartment
When cleaning, remove
the freezer bin ond flush
o solution of baking soda
(one teospoon) and two
cups of hot (not boiling)
water
through the drain
line with the help of a
meat baster. This will
help
eliminate odor and
reduce the likelihood of
a clogged drain line.
if drain becomes dogged, use a meat baster and
baking-sodo-and-water solution to force the dog
through the drain line.
Condanssr
The condenser Is locoted
behind the base grille, for
most efficient operation,
remove the base grille
(see page 3) and sweep
away or vacuum up dust
that is readily accessible.
For best results, use a brush specially designed for
this purpose, it is available at your Sears store or
service center. This easy cleaning operation should
be done ot least once a year.
Behind Refrigerator
Take care moving your refrigerator away from the
wall. All types of floor coverings can be damaged,
particularly cushioned coverings and those with
embossed surfaces. Pull the refrigerator straight out
and return it to position by pushing it straight in.
Moving refrigerator in a side direction may damage
floor coverinq or refriqerator.
Light Bulb Replacement
Unplug refrigerator before changing a light bulb.
Firesh Food Cosupor'tmemit
interior
1. Pull bottom of light
panel down about
1/4"—just enough to
disengage lip at reor
from grooves in retainers
on rear wall.
2. Lift panel to
disengage top from tabs
on control housing and
remove panel.
After replacing with
same size bulb, reinstall
ponel (hang top on tabs;
pull bottom down and
push it back, and release
it to let lip engage
grooves in retainers).
Grooved
Retoiner-
on© on
each side
Freezer Comparteient
1. Remove shelf just
below light panel. (Shelf
will be eosierto remove
if it is emptied first)
2. Pull plastic light panel towc-rd you. (It will bend to
free tabs from g^ov«,)
'
3. After replacing with same size bulb, reinstall
panel ond shelf.
13