Sears EcoWater CWF - Manual (Page 6)

This display mode shows The remaining
capacity of your filter in months, in this
case, 6 months. (See figure 8.)
By pressing the display button you can move
on to the next display mode. Flow Rate,
Screens: Flow Rate
This display mode shows you at what
rate water is flowing through your filter.
(See figure 9.) This unit Is designed and
tested to operate at 0.75 gpm through
the use of an Internal flow restrictor that
Is dependant upon water pressure. As
slight variations In water pressure may
occur, your display may flicker between
0.7 and 0.8 gpm.
The drawing shows that water Is flowing
through your filter at 0.7 gallons per
minute, (See figure 9.) The water drop
scrolls along the gauge at the bottom
as a second Indicator that water is
flowing through your filter and the water
meter is working properly. Pushing the
display button again would return you to
Screen 1-Capacity Remaining.
Screen 2: Months Remaining ALARM MODES
О D.7S
•
DISPLAY-^
BUTTON
Advisory Beep - 50 gallons left
The water meter will alert you with an
advisory beep when there is less than
50 gallons (200 liters) of capacity remain­
ing In your filter. It Is a single advisory
beep that sounds every 5 seconds when
you draw water, and only when you
draw water. We suggest you contact
your supplier for a replacement filter as
soon as you hear the advisory beep.
(See figure 10.)
Figure 10
Alarm Beep - Filter capacity exhausted
The alarm beep sounds when the capac­
ity of your filter has been exhausted. The
water meter will sound three quick beeps
when water is drawn. The display will
alternate between ’CHANGE FILTER 1'
and the previous screen viewed. The
display will continue to alternate until the
filter has been changed and the meter
has been reset. (See figure 11.)
Figure 9
Poge5