Sears 45520 - Manual (Page 15)

TO SET SELF-CLEAN CYCLE:
1. Close oven door. Push CLEAN. The time display will
show (—). See Fig. 1. You may need to press
slightly on the door.
Fig. 1
2. Press 0 or Q to set the desired length of clean
time. Clean time is normally 3 hours. You can
change it between 2 and 4 hours, depending on how
dirty the oven is. See Fig. 2. The door locks
automatically after the controls are set. The display
will show “LOCK” when door locks.
TO INTERRUPT A CLEAN CYCLE:
1. Push CLEAR/OFF.
Follow Instructions under "WHEN A CLEAN
CYCLE IS FINISHED.”
TO SET DELAYED SELF-CLEAN
CYCLE:
Follow steps 1-2 under “TO SET SELF-CLEAN
CYCLE,” THEN:
3. Press STOP TIME.
4. Set the time of day when you want the clean cycle to
end. See Fig. 4.
The control will calculate the start clean time.
Fig. 2
You can push STOP TIME to find out when the cycle
will end. Push CLEAN to return to countdown.
WHEN A CLEAN CYCLE IS
FINISHED:
1. Walt until the LOCK display goes out. The oven
temperature must drop to a safe level before the door
can be opened. See Fig. 3,
Note: When selecting a stop time for a delayed clean
cycle, you must allow time for the 2-4 hour clean
time.
Your oven light should be OFF during a self-clean cycle
to prolong the life of the bulb.
WAIT UNTIL LOCK GOES OUT
Fig. 3
If you cannot open the door immediately after the word
LOCK goes off, wait about one minute and try again.
14 NESCL07-1