Before startino enoini (cdnt'd), Engine zone controi, Operation – Sears 917.383223 User Manual
Page 9: Imim
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATION
BEFORE STARTINO ENOINi
(CDNT'D)
GAS:
• Fill gasoline tank with fresh, clean unleaded
gasoline. DO NOT USE PREMIUM GASOLINE.
BE CAREFUL NOT TO OVERFILL TANK (SEE
FIG. 8).
WARNING: Experience indicates that alcohol blend
ed fuels (called gasohol or using ethanol or methanol)
can attract moisture which leads to separation and
formation of acids during storage. Acidic gas can
damage the fuel system of an engine while in storage.
To avoid engine problems, the fuel system shouldoe
emptied before storage for 30 days or longer. Drain
the gas tank, start the engine and let if run until the
fuellines and carburetor are empty. Use fresh fuel
next season. See Storage Instructions for additional
information.
Never use engine or carburetor cleaner products in
the fuel tank or permanent damage may occur.
ENGINE ZONE CONTROi
A
CAUTION: FEDERAL REGULATIONS REOUiRI AN
ENGINE CONTROL TO BE INSTALLED ON THIS
LAWN liOWIR IN ORDER TO ffilNIiliZE THE
RISK OF BLADE CONTAG INJURY. DO NOT
UNDER ANY CISCOMSTANCES ATTIIWPT TO DE
FEAT THE FUNCTION OF THE OPERATOR
CONTROI. THE BLADE TURNS WHIN THE ENGINE
IS RUNNING.
Your lawn mower is equipped with an Operator
Engine Control Bar whicn requires the operator
to be positioned behind the Lawn Mower Han
dle to start and operate the lawn mower.
FIG. 8
TO START
imim
® To start a cold engine, push Primer five (5) times
before trying to start. Use a firm push. This step
is not usually necessary when starting an engine
which has already run for a few minutes.
® Push Engine Speed Control Lever forward to
HIGH position.
0 Hold Operator Presence Control Bar down to the
Handle and pull Starter Handle quickly. Do not
allow Starter Rope to snap back.
0 To STOP engine, release Operator Presence Con
trol Bar.
NOTE: In cooler weather it may be necessary to
repeat priming steps. In warmer weather over prim
ing may cause flooding and engine will not start. If
you do flood engine wait a few minutes before at
tempting to start and DO NOT repeat priming steps.
383222