Cortelco Colleague 2204 - Manual (Page 9)

T
ELEPHONE
F
EATURES
PULSE AND TONE DIALING
1.
If your telephone line accepts a touch-tone dialing, set the PULSE/TONE
switch to the Tone position.
2. If your telephone line requires a rotary (pulse) dialing, set the PULSE/
TONE switch to the Pulse position.
3. If you are unsure which system you have, set the switch to the TONE position. Lift
the handset. When you get a dial tone, dial a telephone number. If the dial tone
continues, move the switch to PULSE, and then dial the telephone number again.
4. If the Pulse/Tone Switch is set to the Pulse position and you want to make a tone
entry after pulse dialing, press the * button once, then dial the number.
RECEIVING A PHONE CALL
1.
Be sure the RINGER switch is set to the HI or LOW position.
2. When the phone rings, lift the handset.
3. Set the Ringer switch to the OFF position when you do not want to be inter-
rupted by the phone ringing. Remember to set the Ringer switch to Hi or Low
when you want to receive calls again.
PLACING A PHONE CALL
1.
Lift the handset and wait for a dial tone.
2. Dial the telephone number you wish to call, or depress one of the 10 memory
buttons.
VOLUME BUTTON
A built-in amplifier feature allows you to increase the listening volume in the receiver of
the handset when speaking with your party. When needed, press the VOLUME button
to achieve three different levels. The volume will go back to normal after you hang up
the handset.
REDIAL BUTTON
1.
If the number you dialed is busy, or you want to call the last number dialed again,
lift the handset , or press and release the hookswitch for a new dial tone.
2. Press REDIAL.
3. The last number called (31 digits maximum) will automatically be redialed.
7