Sears KENMORE 758.144151 - Manual (Page 6)

Water Fill (continued)
Notice the water bottles are designed as
right and left hand units. Position them in
the correct location so the humidifier can
function properly. The water bottles should
rest in the front of the cabinet. Each “E-Z-
Fill Side-Cap" must be facing the rear of
the unit.
Each water bottle is designed with an “E-
Z-Fiil Side-Cap" that is easily removable.
Remove the “E-Z-FitI Side-Cap" on the
side of the water bottle by twisting coun­
terclockwise.
Place the opening of the water bottle under
a water faucet (the bottle should fit under a
tour-inch clearance faucet). Fill with rec­
ommended mixture of cold water and
Sears Bacteriostat #42-14900 (if neces­
sary) only. Solid debris could make the
valve leak.
Install the “E-Z-Fill Side-Cap” by twisting
clockwise. Hand tighten only.
Check for possible leaks by performing
the following:
1. Grasp bottle handle and hold the bottle
upright over a sink.
2. Press up on valve cap plunger for about
one second to let out a little water,
3. Release the plunger,
4. Listen for air bubbles. Look for leaks
around the “E-Z-FitI Side-Cap".
5. If you hear air bubbles or see leaks,
retighten the “E-Z-Fill Side-Cap" and
repeat steps 1 -4.
Wipe off excess water from the bottle.
Position the water bottle back into the unit
by grasping the water bottle handle and
lower it into the cabinet until the bottle sits
on pads at bottom of cabinet. The “E-Z-Fill
Side-Cap" must be facing the rear of the
cabinet. When positioned properly, the
plunger will open and water will flow into
the cabinet. The water level will automati­
cally remain at approximately 1/2" until the
bottles are empty.
The unit is now ready for opreration.
Rear of
Should Always Face Rear
Turn Counterclockwise