beautypg.com

Location instructions (continued), Eiectricai hook-up, Water fiil – Sears KENMORE 758.144151 User Manual

Page 5: Electrical hook-up, Water fill -6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Location instructions (continued)

NOTE: Due to release of cool, moist air

from humidifier, it is best to direct air away
from home thermostat and hot air registers.

It is best to position humidifier next to an
inside wail. Hot air registers and cold ar
from outside walls can affect the efficiencies
of the controls. Unit should not be placed
where warm air from a hot air register blows

directly on unit.
Moist air (humidity) produced will disperse

into the whole house, but area closest to the

unit will have the highest humidity. If the unit
is positioned close to a window, condensa­
tion may form on the window pane. If this is

not apprfpriate the unit should be reposi­

tioned in another location.

Eiectricai Hook-Up

Locate nearest 120V A.C. wall socket in

the location desired, preferably on inside
wall. Plug in the electrical cord.

WARNING: To reduce the risk of fire
or shock hazard, humidifier should

be plugged Into a 120V A.C. outlet. Do
not use extension cords

Step 2
The humidifier should be positioned with the

back (cord exit side), at least 2 inches away
from the wall. Air needs to enter through the

louvres in the rear panel in order for the
humidifier to operate at peak efficiency.

electrician to install the proper outlet. Do
not change the plug in any way.

To reduce the risk of electrical shock, this
humidifier has a polarized plug (one blade
is wider than the other). This plug will frt in
a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse plug.

If it still does not fit, contact a qualified

Water Fiil

WARNING: To reduce the risk of shock,

always unplug humidifier before clean­
ing or servicing.___________________________

WARNING: To reduce the risk of fire or
shock hazard, do not pour or spill water

into control or motor area. Close the

control cover. If conUots get wet, let
them dry completely and have unit

checked by an authorized service per­
sonnel before plugging ip.

Pivoting lid Removed
for Clarity

This humidifier is designed for use with the

two water bottles that are located under the

pivoting fid.
Open the pivoting lid of the humidifier.

Remove the water bottles by lifting them
straight up and out of the cabinet.

Fan

Assembly

Water

Bottles

Front of Humidifier