Sears 279787 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. Strip wires back approximately V4 of an inch.
8.
With barrel crimpers, crirnp V*' Insulated female
terminals, induded with motor, onto the vrire leads-
NOTE: Make sure lertnitials are crimped securely
in place.
9.
Connect the white (BN^ wire lead onto the V«” termirval
marked '‘5" on the motor switch.
See F^mte 4.
10. Connect the purple (SNQ wire lead onto tie t /B'termina!
marked on the motor eu^ch.
See f^ure 4.
11. Recormed ground wire to motor.
See F^iue 4.
12. Ml wire lead connections are complete at this point.
You can now reinstallthe motorand bradtet assembly
into unit.