Sears KENMORE 45520 - Manual (Page 14)

то SET SELF*CLEAN CYCLE:
1. Close oven door. Press the CLEAN pad. The time
display will show See Fig. 1. You may need to
press slightly on the door.
Flg.1
2. Press the UP or DOWN arrow pad to set the desired
length of clean time. Clean time is normally 3
hours. You can change It between 2 and 4 hours,
depending on how dirty the oven Is. See Fig. 2. The
door locks automatically after the controls are set.
The display will show “LOCK” when door locks.
Fig. 2
You can push the STOP TIME to find out when the
cycle will end. Push the CLEAN pad to return to
countdown.
WHEN A CLEAN CYCLE IS
FINISHED:
1. Walt until the LOCK display goes out. The oven
temperature must drop to a safe level before the door
can be opened. See Fig. 3.
WAIT UNTIL LOCK GOES OUT
Flg.3
If you cannot open the door immediately after the word
LOCK goes off, wait about one minute and try again.
TO INTERRUPT A CLEAN CYCLE:
1. Push CLEAR/OFF.
Follow Instructions under “WHEN A CLEAN
CYCLE IS FINISHED.”
TO SET DELAYED SELF-CLEAN
CYCLE:
1. Close oven door. Press the CLEAN pad. The time
display will show —). See Fig. 1. You may need to
press slightly on the door.
2. Press the UP or DOWN arrow pad to set the desired
length of clean time. Clean time is nonmally 3
hours. You can change It between 2 and 4 hours,
depending on how dirty the oven Is. See Fig. 2. The
door locks automatically after the controls are set.
The display will show “LOCK” when door locks.
3. Press the STOP TIME .
4. Set the time of day when you want the clean cycle to
end. See Fig. 4.
The control will calculate when to start clean cycle time.
Fig. 4
Note; When selecting a stop time for a delayed clean
cycle, you must allow time for the 2-4 hour clean
time.
Your oven light should be OFF during a self-clean cycle
to prolong the life of the bulb.
CLEANING TIPS
REMOVAL OF PACKAGING TAPE
The safest way to remove adhesive left from packing
tape on new appliances, to assure no damage Is done to
the finish of the product, Is an application of household
liquid dishwashing detergent, mineral oil or cooking oil.
Apply with a soft cloth; DO NOT use a plastic pad or
equivalent. Wipe dry and then apply any appliance
polish to thoroughly clean and protect the surface. This
procedure Is also safe for the face of microwave doors
and other plastic parts.
NOTE; The plastic tape that is not removed from
chrome trim on range parts CANNOT be
removed if baked on.
13
NESCL07-2