Sears 270-3250 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NOTE: For easiest assembly, we recommend not attaching the lower bolt of each handle
bracket until after assembling the chute rotation handle, auger and drive handle cables,
and drive speed control lever.
H
I
I
Figure 2- Handle Assembly
Attaching Drive Speed Control Lever
To attach the drive speed control lever, slide it through the drive speed selection hole in
the handle and attach it at the base of the snow thrower using tvv^o bolts and two nuts as
shown in figure 3. Do not worry about the position of the handle in the drive speed
selection hole. It will naturally be correct.
Figure 3- Drive Speed Control Lever Attachment
10