Sears 74781 - Manual (Page 2)

How to dry a load of laundry
Clean lint screen before' each load.
[ q ) Put laundry into dryer and shut the door.
D)
i Set Cycle Selector Control ||.
Set Heat Temp Control Q.
Set Endk)f Cycle Signal Control Q.
F Push the Start Control Q to start
your dryer.
> Remove load when dry.
D Cycle Selector Control
Use this control to selert the proper drying method for the type of
items in the load. The control can be set for automatic or timed
drying, touch up or air. You can turn the control at any time to
make drying time longer or shorter or you can turn the control to
an OIT position to shut the dryer off.
OPERATING STATUS KEYS
Color coordinated keys indicate in which portion of the cycle the
dryer is operating.
Heat lèmp Control
Use this control to select drying temperature to match fabrics in
the load. The control can be adjusted from LOW for delicate fab­
rics to HIGH for sturdy work clothes.
It is important to choose the right temperature for the type of fab­
rics being dried. A wrong setting could damage some fabrics.
The Heat Temp Control will not work when the dryer is set in the
AIR cycle.
Q End-of-Cycle Signal Control
Use this control to select the loudness of the signal that buzzes to
tell you the drying cycle is over. It can be adjusted to OFF or up
to LOUD. The dryer should be unloaded as soon as the cycle is
over to get the best wrinkle free results. Always use the signal
when drying no-iron fabrics.
During Wrinkle Guard I the buzzer will sound every 5 minutes
unless the control is off.
Start Control
Use this control to start the dryer. Be sure the door is closed.
Opening the door stops the dryer. It will not start again until you
close the door and push the CTART control. Be sure the Cycle
Selector Control is on a dry setting.
Part No. 3392334