How to use your lawn mower, Engine speed (see fig. 6), Engine zone control – Sears 917.373981 User Manual
Page 9: Drive control (see fig. 7), To convert mower, Caution: before attempting to convert lawn mower, Release control bar to stop engine, To adjust cutting height (see fig. 8), Operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED (See Fig. 6)
The engine speed is controlled by a lever located on the
side of the engine. Fast ) position is for starting the
engine, normal cutting, and better grass bagging. Slow
() position is for light cutting, trimming and fuel economy.
ENGINE ZONE CONTROL
A
CAUTION:
Federal
regulations
require
an engine control to be installed on this
lawn mower in order to minimize the
risk of blade contact injury. Do not
under
any
circumstances
attempt
to
defeat the function of the operator con*
trol. The blade turns when the engine is
running.
•
Your lawn mower is equipped with an operator pres
ence control bar which requires the operator to be
positioned behind the lawn mower handle to start and
operate the lawn mower.
DRIVE CONTROL (See Fig. 7)
•
Self-propelling is controlled by holding the operator
presence control bar down to the handle and pushing
the drive control lever forward until it clicks; then
release the lever.
•
Forward motion will stop when the operator presence
control bar is released. To stopfonvard motion without
stopping engine, release the operator presence control
bar slightly until the drive control disengages. Hold
operator presence control bar down to handle to con
tinue mowing without self-propelling.
•
To keep drive control engaged when turning corners,
push down on handle and lift front wheels off ground
while turning lawn mower.
TO CONVERT MOWER
Your lawn mower was shipped ready to be used as a
mulcher. To convert to rear bagging or side discharging,
see TO CONVERT MOWER” in Assembly section of this
manual.
A
CAUTION:
BEFORE
ATTEMPTING
TO
CONVERT LAWN MOWER:
Release control bar to stop engine.
Make sure the blade and all moving parts
have completely stopped.
TO ADJUST CUTTING HEIGHT (See Fig. 8)
•
Raisewheelsforlowcutand lower wheels f or h igh cut.
•
Wheels are set in low cut for shipping. Adjust cutting
height to suit your requirements. Medium position is
best for most lawns.
•
To change cutting height, squeeze adjuster lever to
ward wheel. Move wheel up or down to suit your
requirements. Be sure all wheels are in the same
setting.