Lighting, Warning – Sears KENMORE POWER MISER 153.336431 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Lighting
•WARNING
BEFORE LIGHTING [PROPANE (L.P.) GAS WATER
HEATERS]: Propane (L.P.) gas is heavier than air.
Should there be a leak in the system, the gas will settle
near the around. Basements, crawl spaces, skirted
areas ummr mobile homes (even when ventilated),
closets and areas below ground level will serve as
pockets for the accumulation of this gas. Before
attempting to light or relight the water heater's pilot or
turning on a nearby electrical light switch, be absolute
ly sure there is no accumulated gas in the area. Search
for odor of gas by sniffing at ground level in tbe vicini
ty of the appliance. If odor is detected, follow the steps
indicated at "For Your Safety" on the cover page of this
manual, then leave the premises.
Lighting and operating instructions are located on front of
the water heater, above or to one side of the gas control
valve.
- WARNING -
AN ODORANT IS ADDED TO THE GAS USED
BY THIS WATER HEATER.
FOR YOUR SAFETY
IF YOU SMELL GAS:
1. Do not try to light any appliance.
2. Do not touch any electrical switch; do not use any
phone in your building.
3. Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
4. If you cannot reach your gas supplier, call the fire
department.
WARNING
DO NOT force the gas control knob. Use only your
hand to push it down to light the pilot, or to torn it to
"ON", "OFF" or "PILOT". Never use a tool such as a
lever, wrench or pliers. Do not hit or damage the knob.
A damaged knob may result in an ex^osion and
serious injury. If you have problem turning the knob,
call the gas supplier immediately.
CHECK FOR LEAKS
Be sure to check all your gas pipes for leaks before light
ing your water heater. Use a soapy water solution, not a
match or open flame. Check the factory gas fittings after
pilot is lit and gas control knob is still in "PILOT" position.
Then, check the fittings when the main burner is turned
"ON". Use a soapy water solution for this, too.
Figure 6
Figure 7
Figure 8
Figure 9
14