Assembly – Sears 536.885410 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
THIS SNOW THROWER IS EQUIPPED WITH "TRAC-PLUS" AND ONLY
MOVES EFFECTIVELY WHEN ENGINE IS RUNNING
If your snow thrower must be moved without the aid of the engine, it will be easier to puli the snow thrower back
ward by the handles, rather than pushing.
On start up, the track drive system may be tight and will loosen up as the snow thrower is used. After first use.
check the track for tension and adjust if necessary,. See the Track Adjustment paragraph in the Sen/ice and Adjust
ments section of this manual. Check track adjustment and fasteners regularly.
CONTENTS OF SHIPPING CARTON
1 - Snow thrower completely assembled except for
the crank assembly and the upper handle, which is in
the folded down position.
1 - Parts Bag Containing:
1 - Owner’s Manual (Not Shown)
Parts Shown Below:
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife (to cut carton and plastic ties)
2 - 1 / 2 inch Wrenches (or adjustable wrenches)
2 - 9 / 1 6 inch Wrenches (or adjustable wrenches)
2 - 3/4 inch Wrenches (or adjustable wrenches)
1 - Pair Pliers or Screw Driver (to spread cotter pin)