Homelite 24683 - Manual (Page 3)

INSTALLATION
I ;
CAUTION: DO NOT ATTEMPT TO INSTALL OR WORK
ON THE REVITALIZER WHEN THE TRACTOR ENGINE
IS RUNNING.
slide in place more easily. Fasten the lift bar in place with the
pin and spring clip provided.
1, Position the revitalizer behind the tractor.
2. (See figure 1) Slide the idler arm assembly onto the left
end of the rear lift shaft. Attach the lower end of the idler
arm assembly to the hitch member with a pin and spring clip.
3. (See figure 2) Lower the tractor lift unit and place the re­
vitalizer lift bar assembly into the tube of the tractor rear lift
assembly. Placing a thin film of oil on the lift bar will make it
4. (See figure 3) Move the tractor lift to the raised position.
Connect the revitalizer frame assembly to the tractor with 2
pins and spring dips.
5. (See figure 2) Insure that the revitalizer drive dutch is
pushed all the way back in the disengaged position.
6. (See figure 4) Install the revitalizer drive belt over the rear
power-take-off pulley of the tractor. If-this pulley and the
belt'stops shown in figure 4 have not been previously installed
for use with the revitalizer or rotary tiller, see item (7) and
figure (12) of belt replacement in the Maintenance section of
this manual for proper positioning.
SIDE MOUNTING BELT STOP
FIGURE 4