Homelite Tractors - Manual (Page 3)

36” FRONT BLADE ASSEMBLY INSTRUCTIONS
ASSEMBLY
1. Secure the front blade support to the front of the tractor
using three 3/8" capscrews, lockwashers and hex nuts.
2. Attach the push bar to the blade using a king pin in the
forward hole and a pivot pin in the rear hole.
Alternate holes are provided in the blade to adjust the shoe
assemblies for various types of ground to be plowed. The
blade should be raised when plowing gravel drives or walks.
Lower the blade when plowing asphalt or concrete drives or
walks.
3. Secure the push bar to the front blade support using the
pivot rod. Secure the rod with a quick pin at each end.
The wear plate on the blade is reversible. Should it be­
come worn, it may be removed, reversed and reinstalled.
4. Place the tractor lift lever in the forward position. Using
a yoke pin and quick pin, mount the yoke end of the lift
rod on the lift arm of the push bar assembly. Insert the
hooked end of the rod through the hole in the lift and
secure with a quick pin.
ADJUSTMENTS
The front blade may be angled for plowing to the left or
right. Remove the pivot pin, adjust the blade to the desired
angle and replace the pivot pin.
Recommended Accessories
TIRE CHAINS
RM-5, RM-5E
RM-7
WHEEL WEIGHTS
LM-09901-24
LM-16002-39
LM-09904-49
Note: Loose mounting of chains will make them self-cleaning.