Homelite 1600407 - Manual (Page 3)

ACCESSORIES
TINE EXTENSION SET (Mfg. NO. 1600407)
See Figure 1. The extension set consists of a left and right
tine assemblies with mounting pins and hairpin clips. Mount
long hub of extension over outside end of standard tine as­
sembly and secure assemblies together with pin and hairpin
clip. Be sure sharpened edges of tines on top face forward.
The extension set increases effective tilling width to 31-1/4-
inches.
FURROW OPENER, 8-INCH (Mfg. No. 1600373)
See Figure 2. The furrow opener is intended for digging
furrows for crops which must be planted in rows. To install,
proceed as follows.
1. Remove the depth bar, turn it upside down and bolt it to
the tool holder (A) with the carriage bolts, washers and nuts
provided.
2. Remove the stop plate from between the frame supports
and install the extension support (B) with the old hardware.
3. Position the depth bar in the extension support and re­
install the depth bar clamp using the pin and spring clip pro­
vided. Bolt the furrow opener to the tool holder as shown.
SPECIAL WORM GEAR OIL
CAUTION
Damage to the worm gear drive which results from
use of any lubricant other than that specified will
invalidate the warranty. (See back cover for special
Worm Gear Oil Part Number).
ASSEMBLING
1. Remove all components of tiller from box and place
them in a clean, level area. Inspect each part for damage.
2. Remove belt cover.
3. See Figure 3. Assemble left and right handles to frame
as shown. Note locations of flat washers.
i V
VmLi. m.
FLAT
WASHERS (2)
CAPSCREW,
WHIZ-LOCK
Figure 3.
4. Connect throttle cable as follows:
a. Place throttle control lever in SLOW position.