Outdoor-air damper with hood attached – Carrier 48LJD User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

HEAT ANTICIPATOR SETTINGS - Set heat anticipator
settings at. 14 amp for the first stage and . 14 amp for second-
stage heating, when available.
Step 8 - Make Outdoor-Air Adjustments and
Install Outdoor-Air Hood
MANUAL OUTDOOR-AIR DAMPER - The outdoor-air
hood and screen are attached to the basepan at the bottom
of the unit for shipping.
Assembly:
1. Determine quantity of ventilation required for building.
Record amount for use in Step 8.
2. Remove and save evaporator coil access panel and screws.
See Fig. 12.
3. Separate hood and screen from basepan by removing the
4 screws securing them. Save all screws.
EVAPORATOR
COIL ACCESS ?
PANEL \
SCREWS
(SIDE) “
MANUAL
OUTDOOR-AIR »
ADJUSTMENT
SCREWS
POSITION
SETTING SCALE
Fig. 12 — Damper Panel with Manual Outdoor-Air
Damper Installed
4. Replace evaporator coil access panel.
5. Place hood on front of evaporator coil access panel. See
Fig. 13 for hood details. Secure top of hood with the 4
screws removed in Step 3. See Fig. 14.
6. Remove and save 6 screws (3 on each side) from sides
of the manual outdoor-air damper.
7. Align screw holes on hood with screw holes on side of
manual outdoor-air damper. See Fig. 13 and 14. Secure
hood with 6 screws from Step 6.
8. Adjust minimum position setting of the damper blade by
adjusting the manual outdoor air adjustment screws on
the front of the damper blade. See Fig. 12. Slide blade
vertically until it is in the appropriate position deter
mined by Fig. 15. Tighten screws.
9. Remove and save screws currently on sides of hood. In
sert screen. Secure screen to hood using the screws. See
Fig. 14.
SCREW
HOLES
(TOP)
HOOD
HOOD
SCREEN
LOCATION
(SCREEN NO
SHOWN)
Fig. 14
Outdoor-Air Damper with Hood
Attached
OUTDOOR AIRFLOW (cfm x 100)
Fig. 15 - Position Setting
10