Hoover DEEP SAND U5248-930 - Manual (Page 3)

Fig.3
Red & Green
Lights
Fig. 5
Fig. 6
“Breathe Easy”™ models also have 3 layer,
washable “final filter” in a visible cassette on the
front of the bag housing. These filters trap 100%
dust mites and 99.98% ragweed and common grass
pollens. Like any filter, these must be kept clean to
insure maximum performance. Fig.3.
The On/Off Switch control is located on the front
of the upper handle . Fig 4.
On models with the Embedded Dirt FINDER™
(EDF) feature, the switch (HI & LO) and indicator
lights are located on the top of the bag housing in
easy view of the operator. Fig. 5.
The EDF feature is powered by a 9 Volt battery
which the customer must install.
The DIRT FINDER feature tells the user when dirt
is being removed from the carpet via a small
microphone located in the fill tube. When dirt is
being picked up the mic senses it and the RED light
comes on. When the carpet is clean the light turns
GREEN.
The cleaning tool hose is permanently attached to
the cleaner body through an opening in the hood.
Therefore, the user must insure that the nozzle
control on the front of the hood is set properly for
floor or above the floor cleaning. Suction is diverted
via a gate valve located behind the aeitator cavity.
Settings I to 4 arc carpet (or floor) settings. In any
one of these positions all suction is diverted to the
cleaner nozzle. There is no suction at the end of the
hose. Fig. 6.
Setting 5 is strictly for using the cleaning tools. In
this position, all suction is diverted to the hose and
there is no suction at the nozzle of the cleaner. Fig. 7.
Fig. 7
UVC49