Amana TGA400 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LINT FILTER
The lint filter is located at the front of the dryer in the lower part of
the door opening (see illustration below).
CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. A clean
lint filter insures efficient drying.
The filter can be taken out to remove lint.
TO REMOVE LINT: Wipe across the filter with damp fingers.
TO REMOVE LINT FILTER: Lift filter up and out of door opening.
Filter may be washed if any residue is noticed on it.
TO REPLACE FILTER: Place filter in door recess and push in firm
ly. Be sure the edge of the filter with the word FRONT printed faces
the front of the dryer.
THE LINT FILTER MUST BE IN PLACE IN THE DOOR OPENING
WHEN USING DRYER OR LOADING AND UNLOADING DRYER.
L I N T F I L T E R
EXHAUST SYSTEM
We recommend the dryer be exhausted to the outside atmosphere to
assure maximum drying efficiency. The duct pipe should be cleaned
periodically to remove any obstructions. Check occasionally to make
sure the flapper on the outside weather hood moves freely, is not
pushed in and that nothing has been shoved against it. Check too that
the flapper is not standing open. If it is open, leaves or even snow
could plug it. Any restriction of the air from the dryer will decrease
drying efficiency.
Page 8