Ram Trucks 2015 Cargo Van Commercial - User Guide - Manual (Page 84)

- Electronic Speed Control SET Indicator
This indicator will illuminate when the cruising speed has been set.
OIL CHANGE REQUIRED
Your vehicle is equipped with an engine oil change indicator system. The Oil Change
Required message will display in the EVIC display for approximately 10 seconds,
after a single chime has sounded, to indicate the next scheduled oil change interval.
The engine oil change indicator system is duty-cycle based, which means the engine
oil change interval may fluctuate dependent upon your personal driving style.
Unless reset, this message will continue to display each time you turn the ignition
switch to the ON/RUN position or cycle the ignition to the ON/RUN position if
equipped with Keyless Enter-N-Go™. To turn off the message temporarily, push and
release the MENU button. To reset the oil change indicator system (after performing
the scheduled maintenance), refer to the following procedure.
Vehicles Equipped With Keyless Enter-N-Go™
1. Without pushing the brake pedal, push the ENGINE START/STOP button and
cycle the ignition to the ON/RUN position (do not start the engine).
2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Without pushing the brake pedal, push the ENGINE START/STOP button once to
return the ignition to the OFF/LOCK position.
Vehicles Not Equipped With Keyless Enter-N-Go™
1. Turn the ignition switch to the ON/RUN position (do not start the engine).
2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you start the engine, the oil change
indicator system did not reset. If necessary, repeat these steps.
Resetting The Light After Servicing
Vehicles Equipped With Keyless Enter-N-Go™
1. Without pushing the brake pedal, push the ENGINE START/STOP button and
cycle the ignition to the ON/RUN position (do not start the engine).
2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Without pushing the brake pedal, push the ENGINE START/STOP button once to
return the ignition to the OFF/LOCK position.
W H A T T O D O I N E M E R G E N C I E S
82