Winco EC6010DR/S - Manual (Page 10)

Page 8
60706--214
1335-00
TROUBLE SHOOTING
—————————————————————————--
PROBLEM (SYMPTOMS) POSSIBLE CAUSES
——————————————————————————
Won’t Start (electric) *Fouled fuel injector.
*Out of fuel.
*Dead battery.
*Defective start switch.
*Defective start solenoid.
——————————————————————————
Voltage too low *Engine speed is too low.
*Generator overloaded.
*Defective stator.
*Defective rotor (field).
——————————————————————————
Circuit Breaker Trips *Defective load.
*Defective receptacle.
——————————————————————————
Voltage too high *Engine speed is too high.
——————————————————————————
Generator overheating *Overloaded.
*Insufficient ventilation.
——————————————————————————
No output voltage *Short in load (disconnect).
*Broken or loose wire.
*Defective receptacle.
*No residual magnetism in generator.
*Defective stator.
*Defective rotor (field).
*Shorted capacitor.
*Defective diode.
———————————————————————————
REF PART NBR. DESCRIPTION QTY
1 93849-015 1.5” Exhaust Clamp 1
2 16337-001 Exhaust Pipe 1
3 97274-000 Heat Tape 8’
4 93849-015 1.5” Exhaust Clamp 1
5 16086-002 Exhaust Support Bracket 1
6 15799-005 Fuel System Bracket 1
7 81332-003 Fuel Pump 1
8 62496-006 Fuel Filter 1
9 58166-001 Running Time Meter 1
10 15615-004 Power Outlet Box 1
11 15620-000 Power Outlet Box Cover 1
12 15906-022 Key Switch Assembly 1
NI 55505-000 3/8” Fuel Line 2.5’
NI 81018-009 3/8” Hose Clamps 4
EXHAUST & CONTROLS