Winco RP55 - Manual (Page 6)

Page 4
60706-200 7190-00
ENGINE CONTROL
MODULE
DGC-2020
DANGER – Explosive Fire Risk
* Never smoke when near batteries
* Do not cause a flame or spark in the battery area
* Always discharge static electricity from your body
before touching batteries by first touching a grounded
metal surface.
SERVICING BATTERIES
Batteries used on these units may over time lose water.
This is especially true if you are using a trickle charger to
maintain your battery. When refilling the battery with
water use only distilled water. Tap water will shorten the
service life of the battery.
DESCRIPTION AND IDENTIFICATION
1. ENGINE CONTROL MODULE (DGC-
2020)
The DGC-2020 Digital Genset Controller provides inte-
grated engine-genset control, protection, and metering in
a single package. Microprocessor based technology al-
lows for exact measurement, set point adjustment, and
timing functions. Front panel controls and indicators en-
able quick and simple DGC-2020 operation. Basler Elec-
tric communication software (BESTCOMSPlus) allows
units to be easily customized for each application. A wide
temperature-range liquid crystal display (LCD) with back-
lighting can be viewed under a wide range of ambient light
and temperature conditions.
Never fill the battery above the fill line. Over filling above
the upper level line may cause the electrolyte to overflow,
resulting in corrosion to the engine or nearby parts.
Immediately wash off any spilled electrolyte following the
procedure above..
CAUTION - NEVER ATTEMPT TO JUMP START THIS
ENGINE. If the battery should accidentally become
discharged disconnect the battery cables and recharge
the battery before attempting to start the unit. Boost/jump
starting this unit improperly will result in PERMANENT
DAMAGE TO THE ENGINE CONTROL MODULE (ECM).
FEATURES
DGC-2020 Digital Genset Controllers have the following
features:
• Local and Remote Generator Control
• Engine and Generator Protection
• Programmable Analog Engine Senders
• ECU Communications via SAE J1939
• Programmable Logic
• Automatic Transfer Switch Control (Mains Failure)
• Integrated RS485
• Auto Synchronizing
FUNCTIONS
DGC-2020 Digital Genset Controllers perform the following
functions:
Generator Protection and Metering
Generator protection guards against over voltage, under
voltage, under frequency, and over frequency. Over current
and phase imbalance protection is available as an option at