Winco DGC-500 TO DGC-2020 ENGINE CONTROL - Manual (Page 2)

6. Cut of the lugs on the 10 wires coming up from the generator and strip the
wire back 3/8 of and inch.
7. Insert the ten wires in the following locations on the terminal strips in the new
engine control. The connector may be removed from the board to allow for easy
of installation of the wires.
Wire #
to Terminal #
N 35
G1 41
G2 39
G3 37
401 68
41 69
402 71
42 72
403 74
43 75
8. Plug the engine harness back into the receptacle on the back of the engine
control cabinet. Be sure to gentle lock it in place.
This engine control has been fully programmed for you unit. If everything is
connected and you are ready to run the unit, reconnect the unit to the battery and
depress the run button to manually start the engine generator set.