Winco 2-Wire Conversion Instructions ULPSS15B2W/E - Manual (Page 2)

10. Locate the 2-wire white connector, hanging
loose on the right hand side of the control tower.
Attach it to the matching connector “H” on the
bottom of the new controller “F”.
11. Replace the circuit breaker cover
panel “E” and re-install the 2 bolts “B”.
12. Remove the right side door.
13. Locate the 2-wire white connector on the right side of the engine. Unplug the
white connector and tie back if necessary. See picture below.