Winco 2-Wire Conversion Instructions ULPSS12H2W/E - Manual (Page 3)

WINCO INC.
225 S. CORDOVA AVE.
LECENTER, MN 56057
507-357-6821
SERVICE DEPT.
507-357-6831
wincogen.com
14. Replace the left side door.
15. Re-attach the battery cable if done so earlier.
16. Remove the the operators manual part # 60706-208 for model ULPSS12H4W/E
from the literature package and replace it with operators maual part # 60706-209 for
model ULPSS12H2W/E. This replacement manual contains the proper information
for installation and operation of a 2-wire auto start system. The customer must have
this manual in order to start and operate the unit after the installation of the new en-
gine control.
17. Replace the rear door and access panel.
18. Using the new operators manual, this unit is now ready to be installed as a stan-
dard 2-wire start system. This generator set will now work with any transfer switch
that provides a ‘dry’ relay closure for a start/run signal.
If you have any problems or need assistance,
feel free to contact the WINCO Service
Department at 507-357-6831.
60710-124-11088-01