Winco W6010DE/G - Manual (Page 12)

12 4150-00 60706-245
1. CHANGING THE OIL
Change the oil as recommended in the engine operators
manual. It is usually required to change oil after the fi rst 50
hours of operation and every 200 hours thereafter under
normal operating conditions. If the engine is not used fre-
quently, change the oil every 12 months, regardless of the
actual number of hours of operation.
a. Make sure the unit is level.
b. Start the engine and bring it up to operating tem-
perature.
c. Stop the engine.
d. Remove the oil cap/dipstick (1) to allow the en-
gine to drain more easily.
e. Position a container under the engine to collect
the old oil.
f. Remove the drain plug located on the bottom of
the cylinder block (either side) (2). Allow the oil to
drain completely.
g. After all the oil has been drained from the engine,
install the drain plug (2) and tighten to 14-17 ft. lbs.
h. Dispose of used oil properly.
Before refi lling the engine with oil, the oil fi lter must be
remove and cleaned or replaced.
a. Remove the oil fi lter retaining bolt (1).
b. Pull the oil fi lter cap (2) out and remove the oil
fi lter (3).
c. Clean the oil fi lter or replace if damaged.
d. Install the oil fi lter.
e. Make sure the oil fi lter cap is fully seated (2).
f.
Install and tighten the oil fi lter retaining bolt (1).
g. Refi ll the engine with new oil. Run the engine for
about 5 minutes checking for any oil leaks. After the
engine is warm, shut it off and let it sit for 10 minutes.
h. Recheck the oil level in the engine and refi ll as
required.
Replacement engine oil fi lter part number 114250-35070
or 114299-35110.
2. Servicing Air Cleaners
Check the engine air fi ler check and cleaned after the
fi rst 100 hour of operation and every 200 hour after that.
Consult engine operators manual for additional recom-
mendations. Service more often if it isvery dirty. Replace
the cartridge using only original equipment parts available
at any engine service center.