Wilson Audio WATT Series 7 - Manual (Page 18)

1-6
Because the paint requires a period of several weeks to fully cure, we recommend
that no cleaning fluids such as glass cleaners be used during this initial period of time.
When the paint is fully cured, heavy finger prints and other minor smudges may be removed
with a glass cleaner. Always use the dust cloth. Stronger solvents are not recommended
under any circumstances. Consult your dealer for further information if required. Periodic
polishing may be desired over the years to maintain the high luster of the finish. We recom-
mend a non-abrasive carnuba-based wax and soft cloth.
c
onnecTion oF
y
our
WATT s
PeAkers
The very high current input terminals located on the rear of your WATT 7 loud-
speaker are color coded with a small plastic plug, so that RED corresponds to positive and
black to negative, or common, or ground on the amplifier output. Be sure to connect the
loudspeakers in phase with each other. We recommend the use of the very highest quality
loudspeaker cables, particularly those designed for high frequency propagation correction
and phase linearity. Beware of “zip cord” type speaker cables which will smear the sound
from your WATTs, and limit their effective bandwidth. Also, do not use braided litz type
loudspeaker cables as they will cause an unnatural brightness to the sound, compromise
Figure 2
W a T T / p
uppy
o
Wner
’
s
m
anual