Wilson Audio Mezzo Convergent Synergy - Manual (Page 44)

(see Figure 8). The default rotation is set by using a combination of a spike, nut, and a
diode. If required, additional rotation can be achieved by using the provided 1/2” spacers
between the diode and the bottom of the cabinet (see Figure 8). The amount of rotation
depends on your listening position.
Set the rotation as follows:
1. Remove the casters from the bottom of the Mezzo Convergent Synergy. In-
sert the spike with nut in their place. Turn to Section 10, table 1, locate your
listening position on the table.
2. Assemble the front spikes with the listed diode/spacer combination in Table
1 (see also Figure 5).
3. Install the spikes as shown in Figure 9 above.
Note: the material used for the bottom of the Mezzo Convergent Synergy Wilson’s pro-
S
pacerS
(
uSe only iF
indicated in table
)
S
pike and
n
ut
o
nly
d
iode
, S
pike
,
and
n
ut
f
igure
8 – i
nstalling the
M
ezzo
c
onVergent
s
YnergY
s
pikes
M
e z z o
C
o n v e r g e n t
S
y n e r g y
o
w n e r
’
S
M
a n u a l
44
W i l s o n A u d i o S p e c i a l t i e s
.