beautypg.com

Locating stove – Vogelzang TR001 User Manual

Page 5

background image

VGZ-026 / 20120306.0

Vogelzang International Corp.

TR001 DEFENDER™ /

Page 5

C A U T I O N : K E E P F U R N I S H I N G S A N D
OTHER COMBUSTIBLE MATERIALS AWAY
FROM THE STOVE AND OUTSIDE MINIMUM
CLEARANCES.

CAUTION: REPLACE FIREBRICKS BEFORE
FIRING WOODSTOVE. POSITION FIREBRICKS
SO NO GAPS REMAIN BETWEEN BRICKS.

LOCATING STOVE

Fig. 1 – TOP VIEW Minimum Clearance Dimensions from Combustible Surfaces

FLOOR

PROTECTOR

DASHED LINES SHOW HORIZONTAL CHIMNEY CONNECTOR

AND ADDITIONAL FLOOR PROTECTOR REQUIRED BENEATH

AND EXTENDING 2” BEYOND EACH SIDE

NON COMBUSTIBLE CONSTRUCTION IN ACCORDANCE WITH NFPA 211

BACKWALL

SIDEWALL

8"min.

17"

41"

16"min.

6"min.

23"

15"

min.

12"min

TOP VIEW

35"

sections with three (3) sheet metal screws no more
than a maximum of 3˝/76mm apart in each stove
pipe and/or elbow joint to firmly hold the pipe sec-
tions together.

DO NOT CONNECT THIS STOVE

TO ANY AIR DISTRIBUTION OR DUCT SYSTEM.

5. R e c h e c k c l e a r a n c e s f r o m t h e s t o v e ,

connector stove pipe, and corner clearanc-
es using the illustrations in figures 1–3 and
your local building codes or fire protection
ordinances.

NOTE: Drywall faced with brick or stone must
be considered a combustible surface.

6.

Do Not install this stove in a mobile home,
Manufactured Home, trailer or Tent – NO
EXCEPTIONS! (HUD Federal Standard: 24 CFR
Ch.xx)

7. T h e c l e a ra n c e s p r ov i d e d a r e m i n i mu m

dimensions determined by Omni Test Lab-
oratories, Inc., the manufacturer’s testing
laboratory. Installation of this stove must
comply with the latest edition of NFPA 211 for
reduced clearances and/or your local build-
ing code rulings. Use whichever minimum
dimensions are LARGEST.

Failure to follow these minimum clear-
ance requirements may result in an unsafe
installation and could cause a fire.

Continued on next page

8. This stove meets U.S. Test Standard: UL 1482-1996.
9. Always locate stove to provide a source of fresh

air into the room where the unit is installed.
Failure to do so may result in air starvation of other
fuel burning appliances and the possible develop-
ment of hazardous conditions.