Vizualogic A-1285 - Manual (Page 7)

™
5
section III - system set-up/sub-menu controls
Enter the Sub-Menu, touch the “MENU” button on the screen to enter the Sub-
Menu. Use the “” and “” buttons to move up and down within the Sub-
Menu. Once the desired item has been highlighted, press the “MENU” button
until the desired setting is achieved.
IR CHANNEL – This function changes the IR channel that the monitor transmits
from: Ch.‘A’, Ch.‘B’ or ‘OFF’
NOTE: The driver’s side monitor is factory preset to ‘A’ and the passenger side monit or
is factory preset to ‘B’. DO NOT set both monitors to the same IR channel, as this causes
audible interference through the IR headphones.
SCREEN - Sets the power-up mode for the monitor when system power is turned
on.
• “AUTO” - While in this mode the monitor will resume the last state it
was in when the system power was last turned off.
• “ON” - When system power is turned on, the monitor will always turn
on.
• “OFF” - When system power is turned on, the monitor will always
remain off. The monitor must be turned on manually using the power
button on the monitor or remote.
DVD MODE - Assigns the headrest identity to ensure proper source identification
between Driver DVD, Passenger DVD, Ext. Aux, and Aux. via the on-screen
display (OSD).
NOTE: The dual DVD headrest system’s default setting for the driver’s side is set to
‘Monitor 1’ and ‘Monitor 2’ for the passenger side. The single DVD headrest system’s
default setting for the driver’s side is set to ‘DS’ and ‘PS’ for the passenger side. Do not
set both screens to Monitor 1 / DS or Monitor 2 / PS. These settings must be observed in
order to utilize the integrated FM modulator functions properly.
EXIT - Exits the sub-menu.