VACUUBRAND MPT 200 - Manual (Page 6)

page 6 of 20
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999226 // 07/10/2011
☞ Attention! Magnetic field.
☞ Persons with active body aids (e.g. cardiac pacemakers) must keep a minimum
safety distance of approx. 10cm (4in) to the magnetic unit of the MPT 100 (see
also safety symbols on the vacuum gauge head).
• Use only genuine spare parts and accessories. Otherwise safety and perform-
ance of the equipment as well as the electromagnetic compatibility of the equip-
ment might be reduced.
Possibly the CE mark becomes void if not using OEM spare parts.
Electronic equipment is never 100% fail-safe. This may lead to an ill-defined sta-
tus of the equipment or of other connected devices. Provide protective measures
against malfunction and failure. Ensure that in case of failure the device and the
vacuum system always will turn into a safe status.
Maintenance and repair
The vacuum gauge head itself is maintenance-free.
A damp cloth may be used to clean the vacuum gauge head at the outside. Ensure
that the MPT 100 is first disconnected from the vacuum gauge DCP 3000.
• Attention: Due to the operation the equipment might be contaminated by harmful
or dangerous substances, clean or decontaminate prior to exposure.
The vacuum gauge head is not prepared for customer repair.
Return the vacuum gauge head to the factory for repair.
Vacuum gauge head failures due to contamination are not covered by the warranty.
Opening the vacuum gauge head will void any warranty.
Returned products will not be repaired until the completed health and safety clear-
ance form has been received. In order to comply with law (occupational, health and
safety regulations, safety at work law and regulations for environmental protection)
vacuum pumps, components and measuring instruments returned to the manufac-
turer can be repaired only when certain procedures (see section ” Notes on return
to the factory”) are followed.
NOTICE
NOTICE