Cleaning and assembling components – VACUUBRAND PC 2004 VARIO without controller User Manual
Page 22
page 22 of 25
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. manual-no.: 999080 / 24/04/2008
Round bottom flask 500 ml, coated .......................... 638497
O-ring 28 x 2,5 ......................................................... 3120553
(FPM) at the spherical ground joint of the round bottom flask at
the inlet
alternative:
O-ring 28 x 2,5 ........................................................... 638304
(FEP) at the spherical ground joint of the round bottom flask at
the inlet
☞ Remove union nut at the condenser and remove hose from
the inlet of the condenser.
☞ Pull off old overpressure safety relief device and install new
one.
☞ Connect hose to the inlet of the exhaust waste vapour con-
denser and tighten union nut.
Overpressure safety relief device ............................. 638821
(at the exhaust waste vapour condenser)
Cleaning and assembling components