TYREDOG TD-4000A-X - Manual (Page 30)

30
warning range, each 1
P.S.I. up, warnings
will be given as well.
getting high on. Repeat for 5 times.
8. Learnable sensor is
integrated
Finish learning
mode
Beeps once
Troubleshooting
The following checklist will help you remedy problems you may
encounter with your unit. Before going through the checklist below,
check the connection and operating procedures.
1. Indications disappear from / do not appear in the display
A. Please make sure if power switch is on.
B. Please make sure if monitor has battery inserted.
C. Be sure the power of battery is enough.
D. Be sure to observe the correct polarity when installing the
batteries.
E. If these solutions do not help improve the situation, consult your
nearest Tyredog dealer.
2. No connection between sensors and monitor and you find all tire
pressure values are gone (in 3 dash ‘---‘.)
A. Please make sure if sensor has battery (CR1632) inserted.
B. Be sure to observe the correct polarity when installing sensor
batteries.
C. Battery could run out of power and we suggest to replace with
new battery.