Toa WT-5810 - Manual (Page 8)

133-07-269-90
URL: http://www.toa.jp/
Power Source 120 V AC (Supplied AC-DC adapter must be used.)
Power Consumption 130 mA (12 V DC)
Receiving Frequency 636 – 698 MHz, UHF
Selectable Channel 16 channels
Receiving System Double super-heterodyne
Diversity System Space diversity
AF Output MIC: –60 dB*, 600 Ω, balanced, XLR-3-32 type connector
LINE: –20 dB*, 600 Ω, unbalanced, phone jack
AF Mixing Input –20 dB*, 10 kΩ, unbalanced, phone jack
Antenna Rod antenna
Receiving Sensitivity Over 90 dB, S/N ratio (20 dBμV input, 40 kHz deviation)
Squelch Sensitivity 18 – 40 dBμV variable
Squelch System Using together of noise SQ, carrier SQ and tone SQ
Tone Frequency 32.768 kHz
Indicator ANT A/B, Audio (peak), Battery alarm, Channel number
Channel Check Usable frequencies scanning
S/N Ratio Over 104 dB (A-weight, unbalanced output)
Harmonic Distortion Under 1% (typical)
Frequency Response 100 – 15000 Hz, ±3 dB
Operating Temperature –10°C to +50°C
Finish Resin, black
Dimensions 206 (w) x 40.6 (h) x 152.7 (d) mm (excluding antenna)
Weight 590 g
9. SPECIFICATIONS
* 0 dB = 1 V
Note: The design and specifications are subject to change without notice for improvement.
• Accessory
AC-DC adapter ........................................... 1
8.4. Channel Detection
Step 1. Press the Set key and the Next key at the same time for over a second.
Channel detection begins, and an idle channel number is indicated flashing on the channel number
display.
Step 2. Press the Next key to select the channel.
Step 3. To set the channel to the unit, press the Set key for over a second until the flashing number turns to
steady light.