Toa RW-4800 - Manual (Page 4)

133-07-210-30
Power Source AC mains (Supplied AC-DC adapter must be used.)
Power Consumption 10 mA (max.)
PC system requirements Intel Pentium or faster processor
Microsoft Windows 95 or later
operating system
32 MB of RAM
10 MB of available hard-disk space (min.)
CD-ROM drive
Video card that supports 800 x 600 or greater monitor resolution
Serial port
Finish Resin, black
Operating Temperature –10 to +50°C
Dimensions 210 (w) x 44.6 (h) x 180 (d) mm
Weight 1 kg
R R
R R
Note: The design and specifications are subject to change without notice for improvement.
• Accessories
AC-DC adapter ........................................... 1
CD-ROM .................................................... 1
PC connection cable .................................. 1
Equipment connection cable ...................... 1
• Microsoft and Windows are trademarks of Microsoft Corporation. Intel and Pentium are trademarks of Intel Corporation.
Step 4. Connect the RW-4800's I/O port to equipment into which data is written using the supplied cable.
Step 5. Switch on the power of equipment into which data is written.
• For the wireless microphone, load a battery and set the power switch to ON position.
• For the WT-4810, connect the AC-DC adapter.
Step 6. Begin writing.
Step 7. After writing completion, switch off the power of equipment into which data is written.
• For the wireless microphone, switch off its power.
• For the WT-4810, remove the AC-DC adapter.
Step 8. Switch off the PC power.
Step 9. Remove the cable connecting the RW-4800's I/O port to equipment into which data is written.
Step 10. Put the rubber plug in equipment into which data is written.
9. SOFTWARE OPERATION (Example: e2f_a.exe)
Activation: Open the created folder, and double-click [e2_wf_a], [Release] and
[e2f_a.exe] in this order.
Referring to the operation guide: Open the created folder, and double-click [e2_wf_a] and [Readme] in this
order.
End: Click [X] located in the upper right corner of the screen.
10. SPECIFICATIONS