Toa D-911 - Manual (Page 2)

1. Input fader
Adjusts the volume of each input equipment (i.e.
microphones and CD players).
Fader position "0" provides the minimum volume, and
position "10" the maximum volume.
2. Control key
Recalls preset memories or controls the contact. Lights
when the preset memory is recalled or the contact is
turned on. (Functions can be assigned to the contacts
at the mixer.)
3. Remote (Activation) switch
Setting this switch to the ON position closes the remote
(activation) output terminals (6) on the rear panel, and
setting this switch to the opposite side opens the output
terminals.
4. Output volume control knob
Adjusts the output volume.
Position "0" provides the minimum volume, and position
"10" the maximum volume.
5. Name indication spaces
Used to indicate input and output names, preset
memory contents, and other features for convenience of
operation.
(Example: CD player)
Notes
• When connected to the D-901 digital mixer, volumes can
be adjusted for all channels of the D-901.
• When connected to the D-2008SP digital mixer, desired
input and output channels can be assigned freely to the
input faders (1) and output volume control knobs (4) for
volume adjustments using the D-2000 Setting Software.
For details, refer to the instruction manuals attached to
the D-2008SP.
5. NOMENCLATURE AND FUNCTIONS
[Front]
[Rear]
1 2 3 4
5
6 7
6. Remote (activation) output terminals
Setting the Remote (activation) switch (3) to the ON
position closes the output.
7. VCA control module connection terminals
These terminals are used exclusively for the D-984VC
VCA Control module. Use an RJ45 connector for
connection.
Note
Avoid connecting any other than the D-984VC to these
terminals.
133-12-943-4A
URL: http://www.toa.jp/