TeeJet FieldPilot Install John Deere 4710 & 4720 - Manual (Page 15)

www.teejet.com
16
FieldPilot ®
8. install the ValVe control cable
Connect the FieldPilot valve control cable (E) to the coils on the FieldPilot valve and route the cable into the
cab. Connect it to the SCM harness. Do not be concerned at this time about which connector is connected to
which solenoid coil.
Figure 1-10: Install Valve Control Cable
e
9. install steering disengage sensor
Remove the shields around the steering column in the cab. Mount the bracket from kit (W) as shown. Glue
magnets to the steering shaft (the magnets will need to be cut in half because the shaft is small). Install the
sensor in the bracket. Set the clearance between the magnet and the sensor as close to 1/8” as possible.
Figure 1-11: Install Steering Disengage Sensor
Bracket
sensor