TechniSat TechniCorder ISIO STC - Manual (Page 37)

37
7 Operating the unit
7.1 Switching on
> Switch the digital receiver on by pressing the On/Standby button on the receiver
or on the remote control.
7.3 Switching off
> Press the On/Standby button either on the receiver panel or on the remote control
to switch the receiver off again.
> The receiver is now in ready mode (stand-by) and (if enabled in section 8.2.4 of your
operating manual) on doing so the time is displayed in the receiver display.
If the time is not displayed, it still needs to be acquired by the receiver. To do this,
switch the receiver on and set it to receive e.g. ZDF for approx. 30 seconds to auto-
matically acquire the time.
7.4 Selecting a channel
7.4.1 Using the channel up/down buttons
> To select a channel, use the up/down arrow buttons on the receiver or the
Channel +/- on the remote control to scroll up or down the channel settings.
7.4.2 Using the numeric keypad
> Use the numeric keypad to enter the number of the desired channel.
For example:
1 for channel slot 1
1 , then 4 for channel slot 14
2 , then 3 , then 4 for channel slot 234
1 , then 5 , then 6 then 7 for channel slot 1567
When entering channel numbers with multiple digits, you have approx. three seconds after
pressing a key to complete the entry.
If you wish to enter a number consisting of only one, two or three digits, you can speed
up the entry procedure by keeping the key depressed a little longer on the last digit.
7.4.3 Using the Navigator (channel list)
> Press the OK button.
The channel list navigator is now displayed. In TV mode only TV channels are shown,
and in radio mode only radio channels are shown.
The channel currently selected is highlighted.