Combi 3210 - Manual (Page 4)

Attaching the Canopy
Attaching the Canopy
1. Confirm the canopy is facing in the proper direction.
2. Fully insert the canopy holder (male) to the canopy holder
(female) until a click is heard.
3. Fasten the canopy velcro together around the handle (2
places).
Removing the Canopy
Pull the velcro apart, squeeze the bottom of the canopy hold-
ers (male) and pull the canopy up from above the canopy
holder (female). This must be done on both sides of the
canopy to completely remove it.
CAUTION
Failure to fully secure the canopy holders can cause the
holders to bend. When storing the stroller by laying it
down, be sure the canopy is off the ground to prevent it
from bending.
1. Stand behind the stroller.
2. Locate the small open-
ing on each rear wheel
assembly.
3. Locate the small chrome pin on each rear stroller leg.
Attaching the Rear Wheels
4. Insert the leg into the
wheel assembly until the
small chrome pin locks
into the opening.
Attaching the Seat Cushion
CAUTION
If seat cushion is ripped or torn, do not use.
Do not use the stroller without the seat
cushion.
1. Stand behind the stroller and wrap the top of
the seat cushion around the stroller frame.
2. Attach top right and left seat cushion clips to
the tabs on the stroller frame.
3. Attach bottom right and left seat cushion
snaps to the hooks on the stroller frame.
- 4 -