Combi 3210 - Manual (Page 3)

Assembling the Stroller
1. Remove stroller and rear wheel assemblies
from the plastic bag
2. Remove canopy by detaching rubber bands.
3. Remove front wheel assemblies, guardrail
and stroller handle from inside the stroller.
4. Lift locking lever from stroller frame and
open stroller.
5. Grasp right and left steel tubes and snap
the stroller away from you to open.
6. Insert stroller handle into frame by pressing
chrome buttons into the back of the stroller
frame.
7. Insert long grey tabs into grey plastic slots
on the stroller frame. Grey tabs must be
fully inserted into the slots in order to fold
the stroller.
Attaching & Removing the Front Swivel Wheels
Removing the Swivel Wheels
Press in the square button located at the
bottom of the wheel holder while pulling
the assembly off of the swivel shaft.
Release Button
1. Turn stroller over and remove
packaging material from stroller
frame.
2. Insert the front wheels onto
the stroller leg. Make sure the
swivel wheel lever is behind the
stroller leg and released. You
will hear a click when the wheel
is properly attached.
- 3 -